Spring Axle Pads
In order to install a Spring Over Lift (SPOA) new spring perches are required. It is also advisable to move the front axle 3/4" forward to better clear the firewall. Petroworks spring axle pads come already drilled and ready to weld on.
Sold in Pairs (Specify Front or Rear as they are different)
This product requires Welding by a competent welder as the Samurai axle housing is not very thick.
When installing on the front adjusting the camber angle of the axle is not recommended and these pads should be installed parallel to the OEM models. Adding more camber to the front end will cause the vehicle to shake and become unstable at highway speeds.
When install on the rear axle you should add no more than 3-5 degrees angle to the rear. Too much will cause excessive spring wrapping and driveshaft breakage.